Fisher & Paykel Dryer (Later Generation) — Err2 / E2
Err2 / E2 on a Fisher & Paykel Dryer is a display reading homeowners often search when a cycle stalls or an alarm sounds. This page covers how it typically presents, safe checks, and when to bring in an independent technician — always confirm against docs for the Dryer — later-generation fault codes line.
Content status: Verified
What Err2 / E2 often looks like on Fisher & Paykel Dryer appliances, plus safe next steps.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so Err2 / E2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Summary for Err2 / E2 (Dryer — later-generation fault codes). Independent repair notes only — not a substitute for the current Product Help article or tech sheet for your serial.
Symptoms you may notice
- The dryer display shows Err2 / E2 during or after a drying cycle.
- The cycle may pause, stop early, or fail to start while Err2 / E2 is shown.
- Drying performance may be reduced, or the drum/heater may stop, while the fault is active.
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Check that the door is fully closed.
- Clean the lint filter and check that the exhaust vent/ducting is not blocked or crushed.
- Confirm the load is not overloaded.
- Switch the dryer off at the wall, wait about 60 seconds, then switch back on and retry once.
- Record the full model and serial number from the rating plate.
Important safety warning. Do not open internal panels, remove covers, or access wiring, the heater, or the motor. Do not bypass the door safety switch. If your model is gas-heated and you ever smell gas, stop immediately, leave the area, and contact your gas provider and a qualified technician. If you notice smoke, sparks, or a burning smell, switch off power at the wall and call a professional immediately.
When to call a technician
When Err2 / E2 keeps coming back on your Fisher & Paykel Dryer, stop repeating cycles and request a visit from Fisher & Paykel Appliance Repair. We confirm the reading against your exact model before recommending parts.
Frequently asked questions
If there is water near electrics, smoke, a burning smell, or a gas odor, switch off and call a professional. Otherwise pause cycles, do the safe checks once, and book help if Err2 / E2 persists.
Use charts only as orientation. Confirm against Fisher & Paykel Product Help or the manual printed for your model before acting.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.