Fisher & Paykel DD24ST4DX2 Contemporary Tall Single DishDrawer Dishwasher
Tall single DishDrawer dishwasher; owners most often report wet dishes, water left in the tub or a drawer that will not latch.
Model overview
The DD24ST4DX2 is a tall single DishDrawer dishwasher from Fisher & Paykel, a 23 9/16-inch drawer built to sit behind a Contemporary panel. It holds seven place settings across six wash programs, and fan-assisted drying finishes each load. Concealed capacitive touch controls sit behind a proud handle, and the soft-close drawer closes gently on its own. Across the metro areas we cover, the calls about this drawer tend to be dishes that come out wet or a tub that holds water after a cycle. When you book, add the model string, the program you ran, and whether the drawer stopped partway through.
At a glance
| Model | DD24ST4DX2 |
|---|---|
| Appliance | Contemporary Tall Single DishDrawer Dishwasher |
| Common symptoms | water left in the tub after the cycle; dishes not getting clean or dry; leak or leak-protection code; door latch or control panel problems |
| What you can check | Note the cycle used, whether water is left in the tub, and any code or flashing light. |
| When to call a technician | If the symptom comes back after the simple checks, or you see a code, leaking water or a burning smell, book a visit. |
Specifications
| Dimensions | Width: 23 9/16 inches. |
|---|---|
| Capacity | Holds seven place settings. |
| Features | Six wash programs. Fan-assisted drying. Soft-close drawer. |
| Controls | Concealed capacitive touch interface. |
| Care | Three-stage filtration. |
| Finish | Contemporary proud handle. |
What sets the DD24ST4DX2 apart
Because it is a single drawer, this model suits a kitchen that runs small loads on their own rather than filling a larger tub. Its three-stage filtration keeps food particles out of the wash, so the filters are the first thing to check when dishes come out gritty. The Contemporary proud handle sets the front apart from a flush panel and changes how the drawer is pulled open.
Service notes for the DD24ST4DX2
Dishes that come out wet or dirty usually trace back to a spray arm blocked by debris, a filter that needs cleaning, or a drying fan that stops early, and a technician checks those three before the controls. A drawer that stops mid-cycle often reports a door latch or a control fault, and that path runs through the touch panel. Before the visit, the owner can clear the filters, check that the spray arm turns freely, and confirm the drawer closes fully until the latch engages. Switch the dishwasher off at the breaker before reaching into the tub.
The model number is printed on the rating label, usually on the edge of the door or the side of the tub, visible when the door is open; match it letter for letter before booking, because a single letter can change parts.
Frequently asked questions
How many place settings does the DD24ST4DX2 hold?
It holds seven place settings in a single drawer, with six wash programs to choose from.
Does the DD24ST4DX2 use fan-assisted drying?
Yes. The fan runs at the end of a cycle, so it is the step to check when dishes come out damp.
Where do I find the full DD24ST4DX2 model number?
Check the rating label on the edge of the door or the side of the tub, visible when the door is open. Copy every letter and digit, including the ones at the end.
Do you repair the Fisher & Paykel DD24ST4DX2 at home?
Yes. We book in-home visits for this model in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Add the model number and the symptom to the booking form.
Common issues for this model
- Water left in the tub after the cycle
- Dishes not getting clean or dry
- Leak or leak-protection code
- Door latch or control panel problems
Related error codes
Fisher & Paykel DishDrawer E5 Code: Internal Lid Fault
E5 is an internal lid fault; the guide's loading tips may apply.
Fisher & Paykel DishDrawer F3 Code: Water Temperature Fault
F3 is a temperature fault. What the 65 C limit means and who to call if it persists.
Fisher & Paykel DishDrawer E1 Code: Flood Detected
E1 is a flood fault. One reset is the guide's first step; then disconnect power and water.
Fisher & Paykel DishDrawer F6 Code: Lid or Fan
F6 is a lid fault in one guide, a drying fan fault in another. A restart is the only owner step.
Recommended repair service
DishDrawer Repair
DishDrawer not draining, not filling, leaking, or showing a fault code? We diagnose Fisher & Paykel drawer dishwashers.
Troubleshooting resources
Note the cycle used, whether water is left in the tub, and any code or flashing light.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.