Fisher & Paykel Dryer 30
This guide explains 30 in plain language for Fisher & Paykel Dryer appliances (SmartLoad dryer — legacy fault codes). It is independent repair guidance — not official manufacturer service instructions.
Content status: Verified
30 guide for Fisher & Paykel Dryer: symptoms, checks, and booking an independent diagnosis.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 30 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
This page provides general guidance while 30 is matched to Fisher & Paykel docs for the SmartLoad dryer — legacy fault codes platform. Confirm the label on your rating plate before relying on any interpretation.
Symptoms you may notice
- The dryer display shows 30 during or after a drying cycle.
- The cycle may pause, stop early, or fail to start while 30 is shown.
- Drying performance may be reduced, or the drum/heater may stop, while the fault is active.
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Check that the door is fully closed.
- Clean the lint filter and check that the exhaust vent/ducting is not blocked or crushed.
- Confirm the load is not overloaded.
- Switch the dryer off at the wall, wait about 60 seconds, then switch back on and retry once.
- Record the full model and serial number from the rating plate.
Important safety warning. Do not open internal panels, remove covers, or access wiring, the heater, or the motor. Do not bypass the door safety switch. If your model is gas-heated and you ever smell gas, stop immediately, leave the area, and contact your gas provider and a qualified technician. If you notice smoke, sparks, or a burning smell, switch off power at the wall and call a professional immediately.
When to call a technician
Still seeing 30 after a single power-cycle and the checks above? Book Fisher & Paykel Appliance Repair with the code noted — we diagnose on site and wait for your approval before any repair.
Frequently asked questions
If there is water near electrics, smoke, a burning smell, or a gas odor, switch off and call a professional. Otherwise pause cycles, do the safe checks once, and book help if 30 persists.
Control generations differ. Treat 30 as a pointer for your serial, not a universal parts list.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.