A20 is a not-draining fault with two listed causes: clogged filters or blocked drainage.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so A20 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
A20 is a Fisher & Paykel dishwasher not draining, with clogged filters or a blocked drain as the listed causes.
A20 tells you the dishwasher is not draining, and you will see it with water left standing in the unit. In its A20 support article, Fisher & Paykel sets out two causes in a two-row table.
At a glance
| Code | A20 |
|---|---|
| What it means | The dishwasher is not draining and water is left standing; clogged filters or a blocked drain are the likely causes. |
| What you can check | Switch the dishwasher off, scoop out as much water as you can, and clean the filters. Check that the drain hose has no kinks and that the connection and piping are not blocked. Press START/PAUSE to continue. |
| When to call a technician | If the water stays put after the filter and hose checks, a service technician is needed. Say what you cleaned and checked. On a new installation, also check the drain spigot on the S-pipe was drilled out. |
Check the filters
This is the first cause in the article. Remove as much of the water as you can, for example with a cup and a small towel. Next, clean the filters. Finish by pressing START/PAUSE to keep the program going.
Check the drainage
After scooping the water out once more, the article has you confirm three points.
- The drain hose is free of kinks.
- The connection and piping are right and nothing is blocking them.
- If the dishwasher is a new installation, the drain spigot on the S-pipe has been drilled out.
Only new installations need that last check, and the article is silent on the reason.
Keeping safe
- Switch the dishwasher off before putting your hands near the filters or hose.
- Keep a towel on the floor in case of spills.
- Do not reach behind the unit while the power is connected.
- If a built-in unit has to come out of the cabinet, call for help, because pulling on it can load the hoses.
When the water stays put
According to the article, unsuccessful troubleshooting means a service technician is required. It lists nothing more for the owner. Say that you cleaned the filters and checked the hose, and the visit can begin from there.
Related code
- A3: the DishDrawer’s drain fault, which has its own hose and pipe checks.
Dishwasher repair by phone
We cover the Miami, New York, Houston, Los Angeles and San Diego metro areas for Fisher & Paykel dishwasher repair. Call (844) 659-2290 about a persistent A20 with your model number, and describe what you cleaned and checked.
Source: Fisher & Paykel Support: Dishwasher not Draining and has fault ‘A20’
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.