Fisher & Paykel DishDrawer A09 Code: Sanitize Cycle Too Cool
A09 is a temperature shortfall in the sanitize cycle on DD*C DishDrawers. Check the supply, clear, rerun.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so A09 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
A09 is Fisher & Paykel's code for a sanitize cycle that fell short of its required temperature.
If your DishDrawer has no sanitize cycle, A09 is not for you. Fisher & Paykel’s A-code article restricts it to DD*C models.
At a glance
| Code | A09 |
|---|---|
| What it means | A09 is Fisher & Paykel's code for a sanitize cycle that fell short of its required temperature. |
| What you can check | Confirm the water supply to the dishwasher is on and that nothing interrupted the cycle. Press Start/Pause to stop the beeping, press it again to clear the fault, then start the sanitize cycle again. |
| When to call a technician | If A09 comes back even though the water was on and the cycle ran uninterrupted, the dishwasher still cannot reach temperature and needs a service visit. Note any other code on screen first. |
What the dishwasher is reporting
Sanitizing means heating the water to a set temperature. A09 says the water did not get there. The support article names two simple explanations to eliminate: someone turned the water supply off, or the cycle was cut short before finishing. You do not need tools for either.
Do this, in this order
- Look at the supply to the dishwasher and confirm it is on.
- Confirm nothing interrupted the cycle.
- One press of Start/Pause stops the beeping.
- A second press of Start/Pause clears the fault.
- Start the sanitize cycle again, from the top.
Beeping: fault or just paused?
According to the DishDrawer user guide, fault beeping is continuous. A paused drawer beeps in an intermittent pattern. If the beeping never lets up, treat it as a fault.
If A09 comes back
No failed part is attached to A09 in the sources, and they stop after the steps above. When the water was on and the cycle ran uninterrupted, a second A09 tells you the dishwasher still cannot reach temperature. Service is then the only listed route. It is useful to jot down any other code on screen, as each drawer of a double model may show its own.
Neighbouring codes
- A1: a water supply fault, with a closed tap as the first suspect again.
- E3: the temperature sensor fault on older units, which also notes a limit on incoming water temperature.
- E4: a heating element listed as failed.
DishDrawer repair across our metro areas
For Fisher & Paykel DishDrawer service in the Miami, New York, Houston, Los Angeles and San Diego metro areas, call (844) 659-2290. Have the model number to hand, together with the code and the checks you made. The DishDrawer repair page has more.
Source: Fisher & Paykel Support: A-code displaying on DishDrawer Dishwasher
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.