Fisher & Paykel DishDrawer E3
E3 can share a label across Fisher & Paykel generations. For your DishDrawer (DishDrawer — legacy E-code generation), use this page as orientation, then match the reading to your manual or Product Help entry.
Content status: Verified
Fisher & Paykel DishDrawer alert E3: typical presentation, safe checks, and when to call an independent tech.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so E3 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Official wording for E3 on the DishDrawer — legacy E-code generation line may vary by model. Use the safe checks below and refer to your model manual for the exact meaning.
Symptoms you may notice
- The DishDrawer control panel displays E3 during or after a wash cycle.
- The cycle may pause, stop early, or fail to start while E3 is shown.
- An indicator light or beep may accompany the E3 display.
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Check that the drawer is fully closed and latched before restarting.
- Confirm the water supply tap is fully open and not kinked or restricted.
- Check that the drain hose is not kinked and the drain path / air gap is clear.
- Switch the DishDrawer off at the wall, wait about 60 seconds, then switch back on and retry once.
- Record the full model and serial number from the rating plate for reference.
Important safety warning. Do not open internal panels, remove covers, or access wiring or the control board. Do not bypass the drawer safety interlock. If you notice water pooling near electrical parts, a burning smell, or sparks, switch off power at the wall and call a professional immediately.
When to call a technician
If E3 returns after the safe checks, pause further DIY and book an independent diagnosis with Fisher & Paykel Appliance Repair — bring the model/serial and a photo of the display.
Frequently asked questions
No. Codes are model-dependent and sealed/gas/high-voltage work is technician-only. Use the checks above, then book independent service.
Use charts only as orientation. Confirm against Fisher & Paykel Product Help or the manual printed for your model before acting.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.