Fisher & Paykel DishDrawer A7 Code: Excess Foam Detected
A7 means excess foam was detected and the dishwasher started auto recovery. Leave it to finish.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so A7 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
A7 is the Fisher & Paykel DishDrawer auto recovery program, started after excess foam was detected in the drawer.
On a DishDrawer, A7 means the dishwasher found excess foam in the drawer and began an auto recovery program. It is the machine acting on a problem, not announcing a failure. Fisher & Paykel tells you first to leave it running.
At a glance
| Code | A7 |
|---|---|
| What it means | A7 is the Fisher & Paykel DishDrawer auto recovery program, started after excess foam was detected in the drawer. |
| What you can check | Let the auto recovery program run to the end and do not add more detergent. Before the next wash, make sure you are using the right type of detergent, and wipe up any spilt rinse aid. |
| When to call a technician | If the drawer is still full of foam when the wash program finishes, arrange a service visit. |
The manufacturer’s sequence
- Allow the auto recovery program to complete; the wash program carries on by itself once it does.
- Check, before another wash, that the detergent you are using is the right type.
- If foam still fills the drawer after the wash program ends, contact Customer Care.
Support’s phrasing is a little different: when foam remains at the end of the cycle, book a service.
What tends to cause foam
According to the DD24DAX9 / DD24SAX9 user guide, these are unsuitable for the DishDrawer: liquid detergents, laundry detergents, hand washing liquids, soaps and disinfectants. The troubleshooting table lists foaming as the outcome of using the wrong detergent. Rinse aid is the other culprit named, because spilt rinse aid leads to excessive foaming, so mop up spills near the dispenser straight away.
Quick list
- Leave the recovery program to run to the end.
- Resist adding more detergent to fix it.
- Dry off suds that spill over, as water on the control buttons should be wiped.
After A7 clears
Start the next cycle with the correct detergent in the right quantity from the dispenser. A drawer that is still foam-filled when the wash program finishes is a case for Customer Care, says the manufacturer.
Related codes
- A6: the spray arm fault.
- A3: a drain fault, relevant when water does not leave after the foam has cleared.
DishDrawer repair support, metro by metro
Where A7 repeats, our line at (844) 659-2290 takes calls about Fisher & Paykel DishDrawer service in the Miami, New York, Houston, Los Angeles and San Diego metro areas. It helps to name the detergent and describe the drawer at the end of the cycle.
Source: Fisher & Paykel DishDrawer DD24DAX9 / DD24SAX9 User Guide; Support: A-code displaying on DishDrawer Dishwasher
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.