Fisher & Paykel Washer 130
This guide explains 130 in plain language for Fisher & Paykel Washer appliances (SmartDrive top-load washer — legacy fault codes). It is independent repair guidance — not official manufacturer service instructions.
Content status: Verified
130 · Washer — cautious homeowner guidance for this display reading (verify for your serial).
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 130 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
This page provides general guidance while 130 is matched to Fisher & Paykel docs for the SmartDrive top-load washer — legacy fault codes platform. Confirm the label on your rating plate before relying on any interpretation.
Symptoms you may notice
- The washer display shows 130 during or after a wash cycle.
- The cycle may pause, stop early, or fail to start while 130 is shown.
- The machine may not fill, agitate, spin, or drain normally while the fault is active.
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Check that the lid or door is fully closed (and locked, on models with a lid/door lock).
- Confirm the water supply taps are fully open and hoses are not kinked or restricted.
- Check that the drain hose is not kinked and the drain/standpipe is clear.
- Confirm the load is not overloaded or unbalanced.
- Switch the washer off at the wall, wait about 60 seconds, then switch back on and retry once.
- Record the full model and serial number from the rating plate.
Important safety warning. Do not open internal panels, remove covers, or access wiring, the motor, or the control board. Do not bypass the lid/door safety switch. If you notice water pooling near electrical parts, a burning smell, or sparks, switch off power at the wall and call a professional immediately.
When to call a technician
Still seeing 130 after a single power-cycle and the checks above? Book Fisher & Paykel Appliance Repair with the code noted — we diagnose on site and wait for your approval before any repair.
Frequently asked questions
Try only the safe checks listed here and a single wall-power restart. If 130 returns, stop DIY — the underlying condition needs a proper diagnosis.
No. This is independent repair guidance from Fisher & Paykel Appliance Repair. For official wording use Product Help and your model’s docs.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.