Code 1 on a Fisher & Paykel washer means a failed write to the EEPROM memory chip. The manual lists module replacement, a job for service.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Fault 1 reports a failed EEPROM write by the Motor Controller module, or by the Display module on Phase 1, across Phases 1 to 6.
Fisher & Paykel’s service manual opens its list of detailed faults with fault 1, and the entry is short. An attempt by the Motor Controller module to store data at an EEPROM address did not succeed. On a Phase 1 washer, the Display module is the one named. The range is Phases 1 through 6.
At a glance
| Code | 1 |
|---|---|
| What it means | Fault 1 reports a failed EEPROM write by the Motor Controller module, or by the Display module on Phase 1, across Phases 1 to 6. |
| What you can check | Write down the code and the washer's model name, and take the washer off power at the wall. There is no reset or check an owner can do for this code. |
| When to call a technician | A technician has to replace an electronic module to fix this. Keep the console closed and tell the visitor what the display showed. |
Reading the entry
| Term | Meaning |
|---|---|
| EEPROM | A small memory chip holding settings through a power-off |
| Write error | The module tried to store data and the attempt failed |
| Source | A single module; the manual lists nothing further down the chain |
What the manual prescribes
Swapping the module is the listed action. No reset sequence, wiring check or owner step is given for code 1. The manual addresses technicians, and the part is electronic, so home repair is out.
According to the manual, what the display shows is whatever fault was recorded most recently, and confirming it is always required. Jot down what the washer showed so that it is available when the technician begins.
Before the appointment
- Write down the code and the model name, which identifies the Phase.
- Keep the console closed and take the washer off power at the wall when anyone is about to work on it.
Memory codes nearby
- 3: a memory error picked up by the Motor Controller
- 7: a memory fault picked up by the Display module
Washer service across our metro areas
Smart Drive washer calls are taken for the Miami, New York, Houston, Los Angeles and San Diego metro areas on (844) 659-2290. Have the code, the model name and any previous codes ready.
Source: Fisher & Paykel Phase 6 Series 11 (GWL11) service manual 517766, Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.