Code 3 is a memory error in the Motor Controller Module on Phase 1 to 6 washers, with replacement as the listed action.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 3 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The Motor Controller Module found a memory error, Phases 1 to 6.
The entry itself
For 3 the manual says the Motor Controller Module has found a memory error. The listing spans Phases 1 to 6 and is headed Motor Controller Module Fault.
At a glance
| Code | 3 |
|---|---|
| What it means | The Motor Controller Module found a memory error, Phases 1 to 6. |
| What you can check | Nothing can be attempted at home for this code. Note what the washer was doing when it appeared, such as whether a cycle began at all. |
| When to call a technician | The controller module has to be replaced by a technician. Give the code and model, plus what you noticed before the fault showed. |
- Primary source: the Motor Controller module.
- Action: replace that module.
- Not listed: a second source, a reset or an owner check.
In everyday terms, the washer’s own electronics report that part of their memory is wrong.
What the manual omits
It does not say which memory is affected, whether settings or the running program are involved, or what caused the damage. Nothing can be attempted at home, so see this as a fault that ends in a technician’s visit.
Other memory codes
| Code | Manual wording |
|---|---|
| 1 | failure while writing an EEPROM address |
| 7 | memory fault found by the Display Module |
| 60 | Motor Controller memory check fault when power comes on |
Before calling
Compare the number you saw with the entries above, and recall what the washer was doing when it appeared, such as whether a cycle began at all. Both details are useful to whoever services it.
Fisher & Paykel washer repair in the Miami, New York, Houston, Los Angeles and San Diego metro areas
Call (844) 659-2290 and give code 3 with the model.
Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.