Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 60: Memory Check Fault

Error code 60
Appliance Washer
Quick answer

Code 60 is a Motor Controller memory comparison that failed at power-up. The manual's answer is to replace the module.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 60 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

The Motor Controller's power-up memory comparison with a known reference found differences (Phase 4 to 6).

Phase 4 to 6 washers switch on with a short self-test, and code 60 is how the Motor Controller module reports a failure in it. The manual describes it as a memory check fault.

At a glance

Code 60
What it means The Motor Controller's power-up memory comparison with a known reference found differences (Phase 4 to 6).
What you can check Note that it appears as the washer powers up, keep the model number handy, and leave the washer unplugged until a technician arrives.
When to call a technician Schedule a service visit, because the only remedy is replacing the controller module. Modules differ between generations, so a technician needs the model number to fit the right one.

In plain terms

When power comes on, the Motor Controller tests its memory against a known reference. If the two differ, it flags the difference. The entry makes no link to water, loads or hoses, because the test is electronic.

The manual’s answer

Point Entry
Primary source Motor Controller module
Action Replace the module
Other sources None
Owner step None

The manual gives one action only, replacing the Motor Controller module, and lists no owner-level step.

A short entry

The entry is one description sentence, one module and one action. The manual’s opening notes say the code displayed is the last recorded fault, and to confirm it each time.

Handy notes

  1. Record that 60 comes up as the washer powers up.
  2. Keep the model number nearby; the manual stresses that modules vary by generation and cannot be swapped.
  3. With the washer unplugged, the module work goes to a technician.

Compared with other memory codes

Code Module Situation
45 Display Memory check at power-up, Phase 5
3 Motor Controller Memory error found, Phases 1 to 6
57 Motor Controller Supply too low for an EEPROM write by the Display

Washer service around our metro areas

For a 60 in the Miami, New York, Houston, Los Angeles or San Diego areas, call (844) 659-2290 and give the model number along with the code.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis