Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 106: Display Module Communications Error

Error code 106
Appliance Washer
Quick answer

Code 106 holds the repair order that several Fisher & Paykel washer communications codes refer to: Display module first, then Motor Controller.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 106 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Display module detected a communications error with the Motor Controller module, on Phases 2 to 3 and Phase 6 IW.

A number of communication codes in the Fisher & Paykel manual say “see fault code 106”, and 106 is the one that actually contains the procedure. It covers Phase 2 and 3 washers plus the Phase 6 IW. Each time, the Display module has recorded a failure in its exchange with the Motor Controller module.

At a glance

Code 106
What it means The display module found an error in its communication with the controller module.
What you can check Note the model name and when it appeared: at power-on, mid-cycle, or after a part was fitted. Do not move modules between positions.
When to call a technician Arrange for a technician, since the display module is replaced first and the controller module next if the fault stays. Quote the code and model name.

Referring codes

Code Where it applies
104 Phases 2 to 6
108 Phase 6 IW displays, CRC error
81 to 95 Phases 2 to 3

Any of these on your machine means this entry is the explanation that applies.

Written procedure

First comes the Display module, the primary source, with replacement as the action. If the fault is still there, the Motor Controller module is next as the secondary source, and it is replaced too. Should the new Motor Controller fix the fault, the manual has the original Display module refitted. No owner reset or cleaning step is listed.

Where an owner helps

  • Say which model name is on the washer.
  • Describe the moment the fault came up: power-on, mid-cycle or following a fitted part.
  • Remember that the displayed code is the last recorded fault, so what you saw happen helps to confirm it.

One thing not to do

Do not remove modules to try them in other positions. They are not interchangeable between models, and a mixed set stops the machine working, says the manual.

Compare

  • 104 and 108: both hand over to this entry
  • 105: the timeout code, which adds a rotor sensor step on Phases 5 and 6

Washer repair in the metro areas we cover

For Miami, New York, Houston, Los Angeles and San Diego metro areas the number is (844) 659-2290. Quote the code and the model name.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) service manual 517766, Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis