Fisher & Paykel Washer Code 45: Display Memory Fault
Code 45 is raised at power-up on Phase 5 machines when the display memory differs from reference. Replace the Display Module.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 45 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
On Phase 5 Smartdrive washers the display found its memory differed from a known reference during the power-up check.
Phase 5 Smartdrive washers carry this entry, which the manual calls the Display Memory Check Fault. As power is applied, the display tests its memory against a known reference. If it finds differences, 45 appears on the screen.
At a glance
| Code | 45 |
|---|---|
| What it means | On Phase 5 Smartdrive washers the display found its memory differed from a known reference during the power-up check. |
| What you can check | Noting that it showed at power-up and keep the model details ready. |
| When to call a technician | A technician needs to replace the display module. Quote code 45 and say it appeared when the washer was switched on. |
At a glance
| Item | Manual entry |
|---|---|
| Phase | 5 |
| When it is raised | On power-up |
| Primary source | Display Module |
| Action | One step: replace the Display Module |
| Secondary source, wiring check, reset | None listed |
Why there is little else to say
The entry gives no cause for the memory difference. Because it is a fault inside the electronics, a homeowner can neither inspect nor clean anything, and the manual lists no user step.
For a call, the facts worth having are the code number, that it showed at power-up, and which model the washer is.
Models
The booklet names these for Phase 5: GW709, GW609, GW509, then MW059, LW095, AW095, and last GWC09, GWM09, GWL09. A separate Phase 5 IW list exists for Intuitive Washer displays, and code 46 belongs there.
Other display codes
- Code 46 covers the Intuitive Display’s internal EEPROM, Phase 5 IW.
- Code 7 is a display memory fault that applies from Phase 1 through 6.
- Code 59 is a Display ID that is out of range.
Display module service across the metro areas
For Miami, New York, Houston, Los Angeles and San Diego area callers, (844) 659-2290 is the number. Have code 45, the model and the note that it appeared at power-up.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.