Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 57: Memory Write Brown Out

Error code 57
Appliance Washer
Quick answer

Code 57 is a brown out recorded while the display tried to save to memory. The Motor Controller module is the manual's answer.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 57 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

The Motor Controller found its 15 V supply too low for an EEPROM write requested by the Display.

Code 57, in the manual “Brown Out During Display EEPROM Write Fault”, is limited to Phase 4 to 6 washers. An EEPROM is the little memory chip where a washer keeps settings that must outlast a power cut or switch-off.

At a glance

Code 57
What it means The Motor Controller found its 15 V supply too low for an EEPROM write requested by the Display.
What you can check Notice whether it appeared once or keeps coming back, keep the console closed while the washer has power, and pass that on.
When to call a technician If it returns, call a technician. A brief electrical disturbance can cause it once, but repeated appearances point to a faulty controller module that must be replaced.

How the fault arises

When the Display wants data saved, it asks the Motor Controller module to carry out the write. The module checks its 15 volt supply beforehand. If that supply is lower than the safe level for a write, the module reports the condition back to the Display and the code is shown.

Causes the manual gives

  • Transients, meaning brief electrical disturbances, at the time of the write.
  • A faulty Motor Controller module.

The Motor Controller is the primary source, and replacing the module is the one action given. The entry carries no owner checks.

Sensible handling

Observe whether the code appeared one time or over and over, and mention that when you call. Keep the console closed while the washer has power.

Nearby codes

Code What it covers
61 Same 15 V brown out test, but when the Motor Controller writes its own EEPROM (Phase 4)
60 Motor Controller memory check failure at power-up
45 Display memory check failure at power-up (Phase 5)

Washer repair booking in our metro areas

Customers in Miami, New York, Houston, Los Angeles and San Diego can phone (844) 659-2290 if 57 returns. Provide the model number and whether it was a single occurrence.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis