Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 61: Controller EEPROM Fault

Error code 61
Appliance Washer
Quick answer

Code 61 is a low-supply warning raised while the Motor Controller saves data to its internal memory. Phase 4 washers.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 61 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Phase 4: before an internal EEPROM write the Motor Controller found its 15 V supply under the safe level.

Only Phase 4 washers (Series 8) can show code 61. The manual’s Phase 4 models include GW708, GW608 and GWL08, with others. The title is a brown out during the Motor Controller’s own EEPROM write.

At a glance

Code 61
What it means Phase 4: before an internal EEPROM write the Motor Controller found its 15 V supply under the safe level.
What you can check Unplug the washer before anyone looks at the electronics, and write down that the code reads 61 along with the model number.
When to call a technician A technician must handle it, because the controller module has to be replaced and that is electronics work. Only the earlier generation of washer shows this code, so give the model.

What the module was doing

An internal EEPROM, a memory chip for settings, was about to be written by the Motor Controller module. The 15 volt supply was measured beforehand and found below the safety level. The write was not carried out, and the condition was reported to the display.

Twin of code 57

Both codes describe the same low-supply test. The question is who asked for the write: the Display in 57, the Motor Controller itself in 61. Code 57 also allows a transient as a cause, while 61 states none.

Manual’s remedy

Point Entry
Primary source Motor Controller module
Action Replace the module
Owner checks None

The module is part of the electronics. Unplug the washer before looking at it, and treat replacement as technician work.

More Motor Controller entries

  • Code 60: the memory check failed at power-up.
  • Code 107: the controller reset itself unexpectedly.

Phase 4 washer service in our metro areas

People in Miami, New York, Houston, Los Angeles and San Diego can ring (844) 659-2290 with the model number, stating that the code reads 61.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis