Fisher & Paykel Washer Code 132: Current Trip (Single)
Fault 132 on Phases 1 to 4 is a single brief current trip. The manual orders wiring, motor, then Motor Controller.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 132 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Single momentary current trip: excess current in the motor or its electronic switches; Phases 1 to 4.
A 132 is what the Motor Controller raises after it catches a single, brief surge of too much current through the motor or its electronic switches. Only Phases 1 to 4 are in the manual’s list.
At a glance
| Code | 132 |
|---|---|
| What it means | Single momentary current trip: excess current in the motor or its electronic switches; Phases 1 to 4. |
| What you can check | Turn the power off at the wall as soon as you see the code, and leave resistance testing alone. Note whether it was a one-off, and any dampness near the washer. |
| When to call a technician | Ask a technician to deal with it, since motor circuits are not a homeowner job. Any water reaching the controller must be traced first, or a new controller could fail the same way. |
Three stages
1. Wiring
The first look goes to the wiring that ties the controller to the stator and to the Rotor Position Sensor.
2. Motor
Next, a technician screens the motor, its harness and its connectors for shorts. A resistance figure is measured across the motor phases from the controller side. Around 12.2 ohm is nominal for Phases 2 to 4, while Phase 5 and 6 Smart Drive units should read near 32 ohms. The rotor sensor, the stator terminal made of brass bridge and the harness get a look for water ingress, physical damage and corrosion.
3. Controller
Once the earlier stages come up clean, the module is changed. Water escaping from the cooling chamber or valves toward the controller has to be traced and repaired beforehand.
Leaks and new controllers
Fixing the leak matters because a new controller left next to it could fail the same way. Mention any dampness you have noticed near the washer.
What you can do
- Turn the power off at the wall as soon as you see the code.
- Leave resistance testing alone: motor circuits fed from the mains are not a homeowner project.
- Note whether it was a one-off. When it keeps coming back, that is 133, the more severe form.
Related codes
Washer service in the Miami, New York, Houston, Los Angeles and San Diego areas
Fisher & Paykel washer repair calls for these metro areas go to (844) 659-2290. Quote 132 and the washer’s model.
Source: Fisher & Paykel Phase 6 Series 11 (GWL11) service manual 517766, Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.