Fault 136 appears when the Motor Controller cannot get the motor started. Causes in the manual range from harness to bearings to controller.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 136 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Motor stall: the Motor Controller could not start the motor; Phases 1 to 6.
When the Motor Controller tries to start the motor and fails, it displays 136. All of Phases 1 to 6 are in the manual’s list for it, so each Smart Drive generation it covers can show the code.
At a glance
| Code | 136 |
|---|---|
| What it means | Motor stall: the Motor Controller could not start the motor; Phases 1 to 6. |
| What you can check | Turning the basket by hand counts as service work with the power off. Note when the code appeared and whether a load was inside. |
| When to call a technician | A technician should find the cause, which could be the wiring, a jammed or seized motor, the position sensor or the controller module. Resistance readings need a meter. |
Causes in the manual
The motor harness may be at fault. So may the motor, which could also be jammed. Other entries: seized bearings or seals, a failing Motor Controller module, and the Rotor Position Sensor or its harness.
What the technician works through
| Part | Check |
|---|---|
| Wiring | Continuity of the motor harness, plugs and motor, judged from a phase-to-phase resistance reading on the controller side. Expect around 12.2 ohm on Phases 2 to 4 and around 32 ohms from Phase 5 and 6 on. |
| Motor | Free movement of the agitator and basket by hand, because the bearings and seals may be seized. Water, mechanical damage or corrosion around the rotor sensor and harness. |
| Motor Controller | New module if neither of the other checks finds anything. |
Of the three, turning the parts by hand sounds the simplest; still, the manual files it under service, and the power stays off while it is done. Resistance values are for a technician carrying a meter.
Notes to pass on
- When the code appeared.
- Whether the washer held a load at the time.
The manual does not tie any sound or symptom to 136.
Codes in the same area
- 130: sensor signal error; the harness check overlaps.
- 54: failure of a motor step, no current seen.
- 160: the basket engaged during agitation.
Washer repair when the drum will not move
Our Fisher & Paykel washer line serves the Miami, New York, Houston, Los Angeles and San Diego metro areas: (844) 659-2290. Tell us the code and the model name.
Source: Fisher & Paykel Phase 6 Series 11 (GWL11) service manual 517766, Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.