Fisher & Paykel Washer Code 130: Single Rotor Sensor Error
A 130 on Phases 1 to 6 means the Motor Controller found one error in the sensor pattern. The manual starts with the harness connections.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 130 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Single Rotor Position Sensor error found by the Motor Controller on Phases 1 to 6.
Fault 130 is logged by the Motor Controller when the signal pattern from the Rotor Position Sensor contains an error. It is valid for Phases 1 to 6, and the word “single” marks a one-time event. Generally, this sensor lets the controller know the rotor position so power to the motor is timed properly.
At a glance
| Code | 130 |
|---|---|
| What it means | Single Rotor Position Sensor error found by the Motor Controller on Phases 1 to 6. |
| What you can check | Power the washer down at the wall when this appears, and do not clean or poke at connectors. Make a note of the timing and how often it repeats. |
| When to call a technician | A technician is required, as it needs a special tester and the sensor, its wiring or the controller module may be at fault. Read out the code and the model name. |
Table of checks
| Level | Items examined | Outcome |
|---|---|---|
| Wiring (primary) | Corroded edge connector at the sensor and at the Motor Controller; damaged contacts at the sensor end of the hall harness | New sensor harness when wiper spacing is uneven between contacts |
| Rotor Position Sensor (secondary) | R.P.S. tester | Replace when it fails the test |
| Motor Controller (tertiary) | No check given | New module |
The socket’s contact sets have two wipers each, hence the spacing measurement. A special tester is involved, so this is not something to try at home.
Causes named in the manual
Either a bad connection somewhere on the harness between sensor and Motor Controller, or a defective sensor.
If it comes back
The manual never suggests ignoring 130. A continuous version exists, 131, and its service procedure is the same as this one.
Owner guidance
- Power the washer down at the wall when 130 appears.
- Do not clean or poke at connectors.
- Make a note of the timing and the frequency of any repeat.
Neighbouring codes
- 136: motor stall, the controller unable to start the motor.
- 134: a current trip plus a rotor position error.
Washer repair in Houston, Miami and other metro areas
Fisher & Paykel washer calls are taken for the Miami, New York, Houston, Los Angeles and San Diego metro areas. Call (844) 659-2290 and read out the code and the Phase or model name, plus anything you noticed about when 130 showed.
Source: Fisher & Paykel Phase 6 Series 11 (GWL11) service manual 517766, Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.