Fisher & Paykel Washer 133
Seeing 133 on your Fisher & Paykel Washer? Start with the non-invasive checks below, note the full model/serial, and treat any “exact meaning” as model-dependent until verified for the SmartDrive top-load washer — legacy fault codes platform.
Content status: Verified
133 · Washer — cautious homeowner guidance for this display reading (verify for your serial).
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 133 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
This page provides general guidance while 133 is matched to Fisher & Paykel docs for the SmartDrive top-load washer — legacy fault codes platform. Confirm the label on your rating plate before relying on any interpretation.
Symptoms you may notice
- The washer display shows 133 during or after a wash cycle.
- The cycle may pause, stop early, or fail to start while 133 is shown.
- The machine may not fill, agitate, spin, or drain normally while the fault is active.
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Check that the lid or door is fully closed (and locked, on models with a lid/door lock).
- Confirm the water supply taps are fully open and hoses are not kinked or restricted.
- Check that the drain hose is not kinked and the drain/standpipe is clear.
- Confirm the load is not overloaded or unbalanced.
- Switch the washer off at the wall, wait about 60 seconds, then switch back on and retry once.
- Record the full model and serial number from the rating plate.
Important safety warning. Do not open internal panels, remove covers, or access wiring, the motor, or the control board. Do not bypass the lid/door safety switch. If you notice water pooling near electrical parts, a burning smell, or sparks, switch off power at the wall and call a professional immediately.
When to call a technician
If 133 returns after the safe checks, pause further DIY and book an independent diagnosis with Fisher & Paykel Appliance Repair — bring the model/serial and a photo of the display.
Frequently asked questions
If there is water near electrics, smoke, a burning smell, or a gas odor, switch off and call a professional. Otherwise pause cycles, do the safe checks once, and book help if 133 persists.
Control generations differ. Treat 133 as a pointer for your serial, not a universal parts list.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.