Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Error 243: Stepper Test

Error code 243
Appliance Washer
Quick answer

243 reports a failed step test of the motor on Phase 6. Wiring is the named cause, with 53 and 54 to read next.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 243 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Phase 6: the controller's motor step test found the motor in the wrong position, a Rotor Position Sensor fault with wiring as the primary cause.

What the code reports

Phase 6 washers can show 243, whose title is Stepper Test Failure. It is filed under Rotor Position Sensor faults: the controller tried stepping the motor as a test, and the motor did not end up where it should.

At a glance

Code 243
What it means The controller's motor step test found the motor in the wrong position, a rotor position sensor fault with wiring as the main suspect.
What you can check There is no owner fix for this code. Unplug the washer and keep the cabinet shut, because checking the wiring takes a meter and access to the motor harness.
When to call a technician Arrange a service visit, since the wiring between controller and motor must be checked first, then the motor, controller and sensor. Give the code when you book.

The manual’s chain in a table

Primary fault Wiring
Action Fault codes 53 and 54
Own steps None

What is in 53 and 54

  • Code 53: the sensor’s step test failed because the motor went in the wrong direction.
  • Code 54: the motor or controller failed its step; no current was detected, the motor is unconnected, or the drive is defective.

The order is wiring between controller and motor first, then motor, controller and sensor, following 53 and 54.

Short advice

The step test is something the controller carries out unaided. When it fails the manual lists wiring as the main fault, and verifying wiring takes a meter and a way into the motor harness. Keep the cabinet shut: unplug the washer and request repair.

A sibling worth a look

Over in the Hall-sensor group, Code 240 covers Phase 6 too and refers readers to 130 and 131.

Why so little about wiring

The manual states wiring and goes no further, with no connector or harness named. Codes 53 and 54 hold the remaining detail, which a technician reads next.

Fisher & Paykel repair across our metro areas

Arrange service in the Miami, New York, Houston, Los Angeles and San Diego metro areas on (844) 659-2290, quoting 243 and the model number.

Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis