Fisher & Paykel Washer Code 47: Basket Check Fault
Code 47 covers Phase 2 and 3 washers whose basket check ended without a valid tub status after 2 minutes.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 47 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The Motor Controller could not determine a valid tub status for 2 minutes during a basket check (Phases 2 and 3).
This code is for Phase 2 and Phase 3 Smartdrive washers. The sequence runs like this: the basket check concluded that the basket had come out of engagement, though the pressure sensor reported an empty tub, and 2 further minutes of checking never gave a valid tub status.
At a glance
| Code | 47 |
|---|---|
| What it means | The Motor Controller could not determine a valid tub status for 2 minutes during a basket check (Phases 2 and 3). |
| What you can check | Think about whether clothing could have snagged in the load, and remove any foreign objects. There is no reset an owner can try for this code. |
| When to call a technician | A technician is needed, since the clutch and pressure tube are inside the machine. Provide the code with the model number. |
Compared with code 40
| Code 40 | Code 47 | |
|---|---|---|
| Tub status | Valid | Could not be determined |
| Phases | 1 to 6 | 2 and 3 only |
Order of checks
- Look for clothes or foreign objects that stop the clutch re-engaging.
- Make sure the pressure tube has neither come loose nor kinked.
- With both in order, suspect the pressure sensor inside the Motor Controller module; the manual changes that module.
Limit of what an owner does
The clutch and the pressure tube both lie within the machine. An owner can mostly say whether clothing may have snagged in the load. For this code the manual offers no reset a user could try.
Models by phase
For Phase 2 the manual names GW701, GW601, GW501, followed by MW051, W015, MW061 and MW071. Phase 3 has GW703, GW603, GW503 and then MW053 with LW035. Only these two groups get the code; newer machines do not carry it.
More basket-check entries
Code 40 is the version listed for every phase from 1 to 6. Code 56 is the later one, for Phases 4 to 6, where no valid status was found.
Washer repair booking by metro area
Service for Phase 2 and 3 washers in the Miami, New York, Houston, Los Angeles and San Diego areas starts at (844) 659-2290. Provide the code with the model number.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.