Codes 81 to 95 all report one communications fault between the Display and Motor Controller. Fault 106 holds the service order.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 81 / 82 / 83 / 84 … may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
A Display to Motor Controller communications error, shown as 81 to 95 on Phase 2 to 3 machines.
Anyone searching for one of these numbers should know that the manual gives no individual explanation. One printed line, “81. – 95.”, carries the label Phase 2 to 3 and the pair Display and Motor Controller, followed by a pointer to fault code 106. One fault, then, can turn up under fifteen different numbers.
At a glance
| Code | 81 / 82 / 83 / 84 … |
|---|---|
| What it means | A Display to Motor Controller communications error, shown as 81 to 95 on Phase 2 to 3 machines. |
| What you can check | Write down the exact number shown, anywhere from 81 to 95, plus your model number, and do not swap any modules around. |
| When to call a technician | A technician will replace the display module first and then the controller module if needed. Only one board is changed at a time. |
Numbers included
| Range | Reading | Phases |
|---|---|---|
| 81 to 85 | Communications error, Display to Motor Controller | 2 and 3 |
| 86 to 90 | Identical | 2 and 3 |
| 91 to 95 | Identical | 2 and 3 |
The 106 procedure
Under 106, the Display module has picked up an error in how it communicates with the Motor Controller. Steps:
- Primary source is the Display module: put in a new one.
- Secondary source is the Motor Controller module: replace that next, and if the fault goes away with it, refit the first Display.
Only one board changes at a time. The first Display comes back if the Motor Controller turns out to be at fault.
Models
The manual includes the GW701, GW601 and GW501 (Phase 2) and the GW703, GW603 and GW503 (Phase 3). They are from its older generations.
Related communication codes
- 104: Display-to-Motor Controller error spanning Phases 2 to 6
- 106: the parent entry for the group
- 105: communications timeout
Communication faults: washer service in our metro areas
Have the displayed number (anywhere from 81 to 95) and your model number ready, then call (844) 659-2290. We cover the Miami, New York, Houston, Los Angeles and San Diego metro areas.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.