Fisher & Paykel Washer Error 9: Size Switch Mismatch
Code 9 appears when the size switch on the display is out of step with the size in memory; the fix depends on the phase.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 9 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Size switch setting does not match the one stored in memory, Phases 1 to 6.
Code 9, “Size Switch Error” in the manual, shows when the size stored in memory and the display’s size switch give different answers. It covers Phases 1 to 6. Recommendations differ with the generation of the washer and with what was just done to it.
At a glance
| Code | 9 |
|---|---|
| What it means | Size switch setting does not match the one stored in memory, Phases 1 to 6. |
| What you can check | If you recently had a part swapped, mention it. Disconnect the washer's power before looking for condensation around the console. Size settings after a part swap are best left to a technician. |
| When to call a technician | Code 9 calls for a service visit, particularly after a board was replaced or moved to another machine. Give the model number and say which board was swapped. |
Early phases by situation
| Situation | Manual action |
|---|---|
| New Display module in a Phase 1, 2 or 3 console | Make sure both size switch plungers sit accurately on the console housing |
| Fault during everyday use | Look for condensation damage, inspect the size switch, or change the Display module |
| Motor Controller module moved to a different size of machine | Reset the stored size switch settings by entering and leaving Option Adjustment mode: hold START/PAUSE, press POWER |
Later generations
On Phase 4 Series 8, Phase 5 Series 9 and 10, and Phase 6 Series 11, the size is reselected in SIZE SETTING MODE. Hold WATER TEMP UP and press POWER to get in. Next:
- 5 kg: press Temperature up and stop when the Cold LED is lit.
- 6 kg: press Water level up and stop when the Low water level LED is lit.
- 7 kg: press Spin speed up and stop when the Hold LED is lit.
Caution
Condensation means moisture around live electronics, so disconnect the washer’s power before you look. A stored size that is wrong after a part swap should be left to a technician.
Compare
Size-setting repair in Miami, New York, Houston, Los Angeles and San Diego
For a size switch fault in the Miami, New York, Houston, Los Angeles and San Diego metro areas, phone (844) 659-2290. Tell us which board was swapped, if any, and what the model number is.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.