Fisher & Paykel DishDrawer U3
U3 can share a label across Fisher & Paykel generations. For your DishDrawer (DishDrawer — F/U display fault codes), use this page as orientation, then match the reading to your manual or Product Help entry.
Content status: Verified
U3 guide for Fisher & Paykel DishDrawer: symptoms, checks, and booking an independent diagnosis.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so U3 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Confirm the exact meaning for this Fisher & Paykel platform (DishDrawer — F/U display fault codes). Treat U3 and verify against Product Help or the model manual for your specific unit.
Symptoms you may notice
- The DishDrawer control panel displays U3 during or after a wash cycle.
- The cycle may pause, stop early, or fail to start while U3 is shown.
- An indicator light or beep may accompany the U3 display.
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Check that the drawer is fully closed and latched before restarting.
- Confirm the water supply tap is fully open and not kinked or restricted.
- Check that the drain hose is not kinked and the drain path / air gap is clear.
- Switch the DishDrawer off at the wall, wait about 60 seconds, then switch back on and retry once.
- Record the full model and serial number from the rating plate for reference.
Important safety warning. Do not open internal panels, remove covers, or access wiring or the control board. Do not bypass the drawer safety interlock. If you notice water pooling near electrical parts, a burning smell, or sparks, switch off power at the wall and call a professional immediately.
When to call a technician
If you are unsure about U3 at any point, step away from internal panels and schedule Fisher & Paykel Appliance Repair. Sealed, gas, and high-voltage work stays with qualified technicians.
Frequently asked questions
No. Codes are model-dependent and sealed/gas/high-voltage work is technician-only. Use the checks above, then book independent service.
Control generations differ. Treat U3 as a pointer for your serial, not a universal parts list.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Fields marked with * are required.