F2 is a motor problem. Clear debris around the rotor with power off, then arrange service.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so F2 / E2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Motor problem; motor rotor fault.
F2 means trouble with the motor that circulates the wash water in a DishDrawer; a motor code stops the cycle. The DD24/DD60 guide calls it “motor problem” and the current support article calls it “motor rotor fault”. On Classic panels the same fault shows as E2.
At a glance
| Code | F2 / E2 |
|---|---|
| What it means | Motor problem; motor rotor fault. |
| What you can check | Silence the beeping, switch the unit off, wait a few seconds and switch it on again. If F2 stays, turn off the power at the supply and remove any debris around the rotor while the power is off. |
| When to call a technician | If F2 remains after the reset and the rotor check, or you found no debris to remove, book a service visit and give the technician the code. |
Owner steps, in order
- Press the button briefly to quiet the beeping.
- Switch the DishDrawer off, wait a few seconds, and switch it on again.
- If F2 has gone, continue as normal.
- If F2 is still displayed, write it down, unplug the unit or turn it off at the power supply, and look up the code in the chart.
- Remove any debris around the rotor (support article). The power must be off while you do this.
- If the fault remains, book a service. The older guide says to phone a service centre or Customer Care and quote the code.
The chart in the older guide lists nothing for F2 except that phone call. The rotor check comes only from the support article, and it is the single hands-on step there. The rotor spins as part of the motor, so debris that jams it can raise this code. Nothing should be dismantled to reach further inside.
What the result tells you
- Debris found and removed, and F2 does not return: carry on and watch the next few cycles.
- No debris, or F2 comes back: service, according to the support article.
Where F8 differs
F8 concerns the electronics that control the motor and is listed as service-only. If the rotor is clear and F2 persists, a technician is needed.
Related entries
- E2: Classic-panel motor fault
- A6 / U6: spray arm trouble, which also stops a cycle but can be fixed by the owner
Motor repair visits for DishDrawers
We serve DishDrawers in the Miami, New York, Houston, Los Angeles and San Diego metro areas. If F2 is not cleared by the rotor check, call (844) 659-2290 and tell us what was removed and whether the code showed up mid-cycle. A model number helps too.
Source: Fisher & Paykel DishDrawer DD24 and DD60 user guide (590030A); Fisher & Paykel Support, F-code displaying on DishDrawer
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.