Fisher & Paykel Freezer Code 14: Heater Short or Fault
Fault 14: heater current is above expectation. A short in the heater or wiring, or a faulty heater.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 14 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Low ambient heater drawing current above the expected level, because of a short or a faulty heater.
When the low ambient heater pulls more current than it should, the display gives fault 14. Fisher & Paykel’s Active Smart service manual offers two possibilities: a short located in the heater or in the wiring leading to it, or a heater that has failed.
At a glance
| Code | 14 |
|---|---|
| What it means | Low ambient heater drawing current above the expected level, because of a short or a faulty heater. |
| What you can check | Press a control button to silence the alarm, or unplug for several seconds to reset it. Keep the unit unplugged until it is inspected, above all if a smell of heat is noticeable, and do not remove rear panels. |
| When to call a technician | Call a technician and report the code and any burnt smell or damaged cable. The wiring and heater checks need resistance readings that you cannot take yourself. |
Understanding a short
Current takes an unintended route in a short, and the amount flowing exceeds the heater’s design. Because excess current and wiring are involved, the safe response is to keep the unit unplugged until it has been inspected, above all when a smell of heat is noticeable.
What service looks at
There are two steps in the manual. First, wiring and connections are inspected at the heater and at the power module. Second, resistance of the ambient heater is checked, and a heater found outside limits is replaced. A wiring short should surface in the first step, a dead heater in the second. Since the code list leaves out the resistance limits, you have no number to test against yourself.
13 against 14
| Fault 13 | Fault 14 | |
|---|---|---|
| Current | Under expectation | Over expectation |
| Cause listed | Open circuit or faulty heater | Short or faulty heater |
| Steps | Wiring and connections at heater and power module; heater resistance, replacement if out of limits | |
For the owner
- Press a control button to silence the alarm.
- Unplug for several seconds to reset it; left alone, it resets itself after 72 hours.
- Do not remove the rear panels.
See also
Heater repair, metro areas
Around Miami, New York, Houston, Los Angeles and San Diego, Active Smart refrigerator heater repair starts with a call to (844) 659-2290. Report the code and any burnt smell or damaged cable. More on refrigerator repair.
Source: Fisher & Paykel Active Smart Refrigerators service manual 517775 (2004), Fault Code Display Status
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.