Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Freezer Code 10: PC Sensor Resistance

Error code 10
Appliance Freezer
Quick answer

Fault 10 is a fresh food sensor reading too low; the manual checks the connection, then swaps the sensor.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 10 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Resistance of the PC (fresh food) sensor is outside the normal range, below 660 ohms.

Fisher & Paykel’s Active Smart service manual labels the fresh food side “PC”. Its temperature sensor there is a thermistor, so its resistance shifts as the temperature changes. Fault 10 says the resistance has dropped below 660 ohms, outside the normal range.

At a glance

Code 10
What it means Resistance of the PC (fresh food) sensor is outside the normal range, below 660 ohms.
What you can check Quiet the alarm by pressing any control button, or unplug the unit for a few seconds to reset it. Do not pull on the sensor wires inside the compartment, and check food temperature by other means.
When to call a technician A technician needs to check the sensor connection at the power module and replace the sensor if needed. Note whether the fresh food side seems too warm or too cold.

Reading the thermistor table

Case Resistance
Normal sensor 25.17 kilohms at -30 C down to 0.9106 kilohms at 50 C
Code 10 less than 0.66 kilohms, under the table’s bottom value
Code 9 (the other direction) more than 45 kilohms, over the table’s top value

Because a figure that low matches no temperature the compartment could really have, the controller reads it as a fault in the sensor or its wiring, not as a refrigerator running warm. The manual names no cause apart from the out-of-range value.

Service order

  1. Look at the sensor connection where it meets the power module.
  2. If that connection is good, the sensor is replaced.

There is also a diagnostic mode that displays the PC sensor temperature through the LEDs. Total the lit values and subtract 40 to get degrees Celsius. It is meant for technicians, and the reading changes fast when a door is open.

While the fault is active

  • To quiet the alarm press any control button; unplugging for a few seconds resets it.
  • Pulling on the sensor wires inside the compartment is a bad idea.
  • Use some other means to check how cold the food is.

Related sensor faults

  • Code 9: the PC sensor again, with a reading that is too high.
  • Code 6: freezer (FC) sensor, too low.
  • Code 4: all sensors low simultaneously.

Refrigerator sensor repair, metro coverage

Service for Active Smart fridge-freezers is available in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Ring (844) 659-2290 with the code from the LEDs and note if the fresh food side seems too warm or too cold. Further information: refrigerator repair.

Source: Fisher & Paykel Active Smart Refrigerators service manual 517775 (2004), Fault Code Display Status

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis