Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Freezer Code 4: All Temperature Sensors Low

Error code 4
Appliance Freezer
Quick answer

Fault 4 means the control sees every temperature sensor under the normal resistance range.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 4 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

All temperature sensors measure outside the normal resistance range, below 660 ohms.

If the freezer flashes 4, the control is complaining about all of its temperature sensors together: each one measures below 660 ohms, which is out of range. It is the low counterpart of code 3.

At a glance

Code 4
What it means All temperature sensors measure outside the normal resistance range, below 660 ohms.
What you can check Press a button to quiet the alarm or take the power away for a few seconds, and note which LEDs are lit. After a fresh switch-on or door closing, allow 20 seconds with doors closed before trusting the code.
When to call a technician A technician must check and possibly reterminate the connector at the power module, or replace the module. Mention anything else on the appliance that misbehaves.

Where 660 ohms sits

The manual’s thermistor table runs down to 0.9106K ohms at 50 degrees C, about 910 ohms. A figure under 660 ohms is lower than even that warmest row. The same table lists 2.186K ohms for 25 degrees C.

Checks the manual lists, in rank order

Rank Step
Primary Look over the 6 way RAST connector at the power module
Secondary Reterminate the 6 way RAST connector
Tertiary Replace the power module

Since all the sensors are involved, none of these steps targets an individual sensor.

Owner actions

Not many. Press a button to quiet the alarm, or take the power away for a few seconds, and note which LEDs are lit. The rest is work for a technician. If the freezer was only just switched on or a door was only just closed, allow 20 seconds with the doors closed for the self-test before trusting what you see.

See also

  • Code 3 covers all sensors reading too high.
  • Code 6 is the freezer (FC) sensor alone reading too low.

Freezer repair in our metro areas

We handle Fisher & Paykel freezer calls in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Phone (844) 659-2290 with code 4 and your model number, and mention what else on the appliance misbehaves. Our refrigerator repair page has the general details.

Source: Fisher & Paykel Active Smart Refrigerators USA service manual 517775, sections 1.0 and 2.0

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis