Fisher & Paykel Freezer Code 1: Power Module Self-Test
Fault 1: the power module did not pass its self-test. Replacing the module is the only action listed.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
At the latest power-up the power module did not pass its self-test.
When an Active Smart refrigerator-freezer shows fault code 1, its power module ran a self-test at the last power-up and failed it. The 2004 Fisher & Paykel service manual lists this single reason, with a single remedy: the power module gets replaced.
At a glance
| Code | 1 |
|---|---|
| What it means | At the latest power-up the power module did not pass its self-test. |
| What you can check | Press a control button to quiet the alarm, or disconnect the appliance from power for a few seconds to reset it; otherwise it stops on its own at 72 hours. Keep door openings to a minimum. |
| When to call a technician | Call for service and give the code number, since the fix is work on the power module. Say whether the alarm came after a power failure or after plugging in again. |
Summary
| Item | Detail |
|---|---|
| Meaning | Power module failed self-test on the last power up |
| Action in the manual | Replace the power module (primary action only) |
| Checks or secondary steps | None listed |
How the fault is announced
The unit puts the fault on its display without being asked and sounds an audio alarm. The red bottom LED flashes in turn with the LED pattern for the code. If you press a control button, the alarm goes quiet and the usual display reappears for 8 seconds, after which the code begins to flash once more.
Codes are binary: each LED carries a value and the lit LEDs add up to the number. The manual shows LEDs worth 2 and 16 lit together as 18.
What you can do yourself
- Disconnect the appliance from power for a few seconds to reset the audio alarm. Otherwise the alarm stops on its own at the 72-hour mark.
- Open the doors as little as possible; the food compartments depend on the appliance running.
- Call for service and give the code number.
Its place in the list
Defrost, sensors, heater and fans occupy codes 2 to 18. Code 1 differs because it is about the module that measures every one of those. Code 3 is worth a look too: all the sensors read out of range at once there, and that situation can likewise implicate the power module.
Refrigerator-freezer service in our metro areas
Fisher & Paykel Active Smart refrigerator-freezer service is offered around Miami, New York, Houston, Los Angeles and San Diego. Dial (844) 659-2290 with the LED pattern, and say whether the alarm came after a power failure or after the unit was plugged in again. See also refrigerator repair.
Source: Fisher & Paykel Active Smart Refrigerators service manual 517775 (2004), Fault Code Display Status
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.