Fisher & Paykel Washer Error Codes E21, E5C, EA and ND
Four codes, one listing: electronic board or software error. Off at the power supply for 30 seconds is the only owner step.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so E21 / E5C / EA / ND may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Electronic board or software error, with a power-supply restart as the sole owner step.
Four codes, one line
A single line in the Flexidose front loader article (WH8060J5) covers E21, E5C, EA and ND, describing a fault in the electronic board or its software. Fisher & Paykel does not try to tell the four apart.
At a glance
| Code | E21 / E5C / EA / ND |
|---|---|
| What it means | E21, E5C, EA and ND all mean a fault in the electronic board or its software. |
| What you can check | Switch the washer off where it takes power, let 30 seconds pass, then switch it on again and see whether the code shows. |
| When to call a technician | A repair is needed when the code shows again after the restart. Have the code and the model details ready when you call. |
Steps
- Switch the washer off where it takes power.
- Let 30 seconds pass.
- Switch it on again.
- If the code shows again, book a repair.
Contents of the article
- A short description of the problem
- The restart steps above
- Advice to have the fault code and model details ready when calling for service
No part, cause or model-specific change is mentioned, and the four codes are not told apart from one another.
Details of the restart
It reads as a sequence: off at the power supply, a pause of 30 seconds, back on. The article describes no shorter wait. A code that has cleared leaves nothing further to do in the article, and a code that comes back leads to a repair booking. Nothing else is listed in between.
Codes that share the heading
E5, E22, E36, E51 and E52 sit under that same heading, but the washer-dryer article assigns them other meanings, so each is covered on its own page.
- E1: door lock, the one message an owner can fix unaided
- E7: motor error with the identical power-off step
Washer service for E21, E5C, EA and ND in major metro areas
Ring (844) 659-2290 if the restart fails. We take calls for the Miami, New York, Houston, Los Angeles and San Diego metro areas; give the code and the model details when you phone.
Source: Fisher & Paykel Support: Front Loader Washer, Flexidose is beeping and displaying an error
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.