Fisher & Paykel Washer Err 37 Code: Drainage Issue and Checks
Err 37 covers a blocked pump filter, drain hose, household drain, or a spigot that is blocked or not drilled.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so Err 37 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Err 37 is a drainage issue with a blocked pump filter, drain hose or household drain, or a spigot that is blocked or not drilled.
How the manufacturer files Err 37
The front load washer fault article from Fisher & Paykel calls Err 37 a “Drainage issue.” Its three accompanying messages are “Drain blocked,” “Spigot blocked or not drilled” and “Pump filter blocked.” Among the codes in that article it has the most checks an owner can perform.
At a glance
| Code | Err 37 |
|---|---|
| What it means | Err 37 is a drainage issue with a blocked pump filter, drain hose or household drain, or a spigot that is blocked or not drilled. |
| What you can check | Switch off and unplug the washer, then clean the pump filter with a towel or shallow tray underneath. Check the hose is at least 600 mm (about 24 inches) high, then look at the house drain and spigot fitting. |
| When to call a technician | Book a service repair if the code is still displayed after those checks. Stop using the washer while the fault keeps recurring, and keep the model details close. |
Possible blockage points
| Point | Action |
|---|---|
| Pump filter | Clean |
| Hose from the washer | Inspect |
| Drain in the house | Inspect |
| Spigot fitting | Confirm open and drilled |
The instruction itself says: clean the pump filter, then look over the hose, the drain and the spigot. A spigot that was never drilled counts as its own fault, so the fitting is part of the check.
Hose height
Mount the hose so that it sits no lower than 600 mm above the floor, about 24 inches.
Working through it
- Switch off the washer and pull its plug before working at the filter.
- Clean the filter, with a towel or shallow tray under it for the water.
- Check the height of the hose along its run.
- Look at the house drain and the spigot fitting.
- If the code is still displayed, a service repair booking is the next step.
The article leaves out how to remove the pump filter on this washer; check the user guide.
If the code stays
Per the article’s tip, stop using the washer while the fault keeps recurring. It also advises keeping the model details close for the booking.
Related codes
- Err 37 in the older Smartdrive manual: the pump is blocked and the water level does not change as it drains
- E7:00 and similar: a motor or electronic issue
Washer repair for drainage errors
Drain-related Fisher & Paykel washer service is available across the Miami, New York, Houston, Los Angeles and San Diego metro areas. After the filter and hose checks, call (844) 659-2290 and list what you have already done.
Source: Fisher & Paykel Help & Support: Front Load Washer Displaying Fault Code
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.