Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 232: Comms Timeout 5 Sec

Error code 232
Appliance Washer
Quick answer

232 is an IW-only 5-second comms time-out. Display is the first listed fault and the Motor Controller the second.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 232 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Phase 6: communications time-out (5 seconds), IW models only; the Display or Motor Controller did not respond in time.

Code 232 appears on Phase 6 washers as a five-second communications time-out. The manual restricts it to IW washers; the Display or the controller of the motor stopped answering in time.

At a glance

Code 232
What it means Phase 6: communications time-out (5 seconds), IW models only; the Display or Motor Controller did not respond in time.
What you can check Powering the machine off and keeping the cover closed does no harm, and that is as far as you should go. There is no instruction to reset it.
When to call a technician Phone a technician, who will replace the display first and then the motor controller if needed. Say whether the washer is an IW model and read out the model number.

Primary and secondary

Rank Fault Action
Primary Display Replace the Display
Secondary Motor controller Replace the Motor controller

Ranking is there to show which module to try first. As far as the manual goes, an owner cannot tell which of the two is at fault.

Unlike the Phase 1 entries

Among the Phase 1 communication entries, 4 and 5 start with switching off at the wall for 5 seconds. 232 carries no instruction like that. Powering the machine off and keeping the cover closed does no harm, and it is as far as an owner should go with this code.

Replace, not test

Each listed action is a module replacement, starting with the Display and moving to the motor controller second. No measurement is offered to confirm either one, and no owner checks are given.

Similar entries

  • 105: communications time-out between Display and Motor Controller on Phases 2 to 6.
  • 108: CRC communications error appearing on the Phase 6 IW display alone.
  • 241: function time-out with a crashed display.

Repair for washers in our service metros

Technicians serve the Miami, New York, Houston, Los Angeles and San Diego areas. Call (844) 659-2290; say whether the washer is an IW and read out the model number.

Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis