Fisher & Paykel Washer Code 42: Rotor Fault, Phase 1
Code 42 is a short Phase 1 entry: a rotor fault with confusing feedback. The manual lists a 5-second power cycle and nothing more.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 42 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The Motor Controller of a Phase 1 Smartdrive washer received confusing feedback, which it records as a rotor fault.
Few Smartdrive entries are as short as this one. For Phase 1 machines, code 42 is a rotor fault, and the entire explanation is that confusing information came back to the Motor Controller as feedback. The manual points to no part as the probable cause.
At a glance
| Code | 42 |
|---|---|
| What it means | The Motor Controller of a Phase 1 Smartdrive washer received confusing feedback, which it records as a rotor fault. |
| What you can check | Switch the washer off at the wall, wait 5 seconds, switch it back on and restart. This is the only step an owner can take. |
| When to call a technician | If 42 returns after the power cycle, a technician should diagnose it. Say that the power-off and restart did not stop it, and avoid guessing at parts. |
Manual action
Power the Smartdrive down at the wall, give it 5 seconds, power it up again, and restart. After that the manual says nothing more: there is no part to replace, no wiring to inspect and no second source.
Limits of the entry
- Cause: not stated.
- Parts: none listed.
- When 42 returns after the power cycle: professional diagnosis, in place of a part picked at random.
Checking the recorded code
The diagnostic table has a level that gives the fault code from the last fault, provided it came within the last 8 cycles. With it a technician can check that 42 truly was the last fault. The booklet also reminds the reader to confirm a fault first.
Rotor and motor codes with more detail
| Code | Manual entry |
|---|---|
| 53 | The step test on the rotor position sensor failed; wiring and sensor checks are listed |
| 54 | The motor step test saw no current |
| 55 | System step fail pointing to the rotor position sensor |
Where to call for washer service
For a Phase 1 Fisher & Paykel washer in the Miami, New York, Houston, Los Angeles or San Diego area, call (844) 659-2290. Say that the power-off and restart did not stop the 42.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.