Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 55: System Step Fail

Error code 55
Appliance Washer
Quick answer

Code 55 is a system step fail on Phases 3 to 6; the manual names the rotor position sensor and two checks.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 55 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

A system step fail on Phases 3 to 6 whose primary source is the rotor position sensor.

Code 55 is called System Step Fail and runs from Phase 3 to Phase 6. The manual gives it no description, just the Rotor Position Sensor as primary source and a pair of checks.

At a glance

Code 55
What it means A system step fail on Phases 3 to 6, with the rotor position sensor as the primary suspect.
What you can check Record it together with the model number, and do not open the console.
When to call a technician A service visit is needed, as the sensor must be tested with special equipment and the wiring checked. If the wiring and sensor test fine, the technician will have no further steps to follow.

Two checks

  • Motor wiring and Rotor Position Sensor wiring.
  • Rotor Position Sensor, tested with an RPS Tester.

What the manual leaves out

Nothing is listed as a secondary or tertiary source, and the reason for the step failure is not given. Entries 53 and 54 run longer and may serve a technician as a comparison.

Phase 4 context

Because the range starts at Phase 3, Phase 4 washers fall within it. The manual’s Phase 4 list reads GW708, GW608, W508, MW058, LW085, AW085, GWC08, GWM08, GWL08, THM08 and THL08.

A technician who finds good wiring and a sensor that passes is left without a further step in the manual.

For the owner

The sensor test calls for an RPS Tester. For 55 the manual lists neither a reset nor a user check, so just record the code and the model.

See also

  • Code 53 is the step fail for the rotor position sensor.
  • Code 54 is the step fail for the motor or controller.
  • Code 130 is a lone rotor position sensor error.

Washer repair in our metro service areas

For a Smartdrive washer around Miami, New York, Houston, Los Angeles or San Diego, call (844) 659-2290 and give the code and model number.

Source: Fisher & Paykel Smartdrive washer service manual 517766 (March 2003), section 19, Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis