Fisher & Paykel Washer Code 51: Diverter Valve Fault
Code 51 means the water level dropped in recirculation on a Phase 5 or 6 Eco washer: the diverter drained, or the solenoid was damaged.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 51 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
On Phase 5 and 6 Eco models the water level dropped during recirculation because water drained instead, or because the valve solenoid was damaged.
Eco washers in Phases 5 and 6 pass their wash water through the machine again, and the diverter valve is what routes it either back round or out to drain. For code 51, the Motor Controller registered a level drop during recirculation, which means water is leaving by the drain when it should be going round again.
At a glance
| Code | 51 |
|---|---|
| What it means | On Phase 5 and 6 Eco models the water level dropped during recirculation because water drained instead, or because the valve solenoid was damaged. |
| What you can check | Switch the washer off and note the code, because the valve test must be done by a qualified technician. |
| When to call a technician | A technician is needed, since the water-diverting valve has to be tested and may be blocked or have a damaged solenoid. Tell them the code is 51 and give the model. |
Manual breakdown
| Role | Entry |
|---|---|
| Primary | Diverter in drain mode when it ought to recirculate; or an external source has sprayed water onto the valve, blowing the solenoid |
| Test | The actuator is tested, by a qualified technician only |
| Secondary | A blockage in the valve, or a broken hinge mechanism |
Code 37 cross-reference
In the pump blocked error the diverter is the fourth item listed. A diverter stuck in recirculation mode keeps the level unchanged while the machine tries to drain, and the manual points the technician here for the check.
Resistance reference
- Diverter valve: between 0.7k and 2.5k ohms, per the specification section.
- Code 52 gives that same window for the wax solenoid, with readings depending on ambient temperature and the time since the valve last moved.
Next door
- Code 52: top-up tried more than 6 times, so the valve will not close or is blocked.
- Code 37: the pump blocked error with a reference to this valve.
Eco washer service in the five metro areas
Eco washers in the Miami, New York, Houston, Los Angeles and San Diego areas are handled on (844) 659-2290. Quote 51 and the model.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.