Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 64: Transducer Signal Low

Error code 64
Appliance Washer
Quick answer

Code 64 is a water-level sensor signal below normal frequency. The manual's action is replacing the Motor Controller.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 64 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Water-level sensor (pressure transducer) signals below the normal frequency, under 66 kHz, reached the Motor Controller on Phases 5 and 6.

Phases 5 and 6 use a water-level sensor that the manual terms a pressure transducer (Ptx). Code 64 is raised when the signal from that sensor falls below the expected frequency, specifically beneath 66 kHz.

At a glance

Code 64
What it means The water-level sensor signal fell below its normal frequency, under 66 kHz, as received by the controller.
What you can check Write down the code and model, and keep the electronics closed while the washer has power. No hose or filter check applies to this code.
When to call a technician This is a technician repair, because the controller module has to be replaced. Match the washer label to your model before the visit so the right part is fitted.

Figures in the entry

Detail Manual’s value
Signal frequency Under 66 kHz
Receiver Motor Controller module
Washers Phases 5 and 6
Primary source and action Replace the Motor Controller module

About the fault type

The electrical signal itself is what is low, and the manual offers no hose or filter check for it.

Phase 5 and 6 model numbers

GW709, GW609 and GWL09 are in the manual’s Phase 5 table, and GW711, GW611 and GWL11 in Phase 6; Intuitive Display (IW) versions are listed apart. Match the washer’s label before assuming the entry fits.

Safe steps

Write down the code and model. Keep the electronics closed while the washer has power. Repair, per the manual, is a module replacement for a technician.

Related high-frequency codes

  • Code 65: the sensor signal again, over 90 kHz.
  • Code 66: over 90 kHz too, and it takes over from 65 as of V41 Motor Controller code.
  • Code 58: the transducer count at its maximum adjustment.

Washer repair in our metro service areas

Booking a visit for 64 in the Miami, New York, Houston, Los Angeles or San Diego areas starts with (844) 659-2290. Please have the model number from the label to hand.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis