Fisher & Paykel Washer Code 58: Pressure Transducer
Code 58 is raised at start-up when a stored pressure transducer count exceeds expectations; the Motor Controller is listed.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 58 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The Display found the stored transducer count above the expected value when Pause or Delay Start was pressed (Phases 4 and 5).
Washers of Phases 4 and 5 can display code 58, the manual’s maximum-adjustment warning for the pressure transducer. The Motor Controller module houses that transducer, which serves as the water-level sensor.
At a glance
| Code | 58 |
|---|---|
| What it means | The Display found the stored transducer count above the expected value when Pause or Delay Start was pressed (Phases 4 and 5). |
| What you can check | Write down the code and model, note whether it showed right after pressing Pause or Delay Start, and unplug the washer before anyone looks inside. |
| When to call a technician | Plan a service visit, as the fix is a new controller module and no hose or load check applies. Mention the Pause or Delay Start timing when you call. |
Timing
The fault is caught right as a cycle is started. After Pause or Delay Start is pressed, the Display examines a number held in memory. A number that is too big produces 58. The manual says nothing of leaks, hoses or loads; the matter is a stored value out of bounds.
The manual’s entry
| Point | Detail |
|---|---|
| Where the manual looks first | The Motor Controller module |
| Remedy given | New module |
| Phases | 4, 5 |
| Owner checks | None given |
What to do at home
The only thing to do is record the code and the model number, since no owner steps exist for it. Anyone looking inside should first turn the washer off and pull its plug.
Similar pressure sensor codes
- 64: signal frequency under 66 kHz.
- 66: signal above 90 kHz, standing in for 65 with later controller software.
- 2: trouble reading the pressure sensor.
Washer service across our metro areas
For 58 in the Miami, New York, Houston, Los Angeles and San Diego areas, call (844) 659-2290 with the model number. Mention if it showed right after Pause or Delay Start.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.