Fisher & Paykel Washer Code 2: Pressure Sensor Read Error
A 2 on the display means the pressure sensor reading failed. The manual's remedy is a new controller module.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
An error occurred while reading the pressure sensor (Phases 1 to 4).
What the manual says
Code 2 sits in the Fisher & Paykel service manual as a failed attempt to read the pressure sensor. Machines from Phase 1 through Phase 4 are covered.
At a glance
| Code | 2 |
|---|---|
| What it means | An error occurred while reading the pressure sensor (Phases 1 to 4). |
| What you can check | Turn the washer off at the socket and write the number down. Do not remove panels, because no owner check exists for this code. |
| When to call a technician | Arrange a service visit with the model number ready. A technician replaces the module that reads the sensor; mention when the code first appeared. |
Module responsible
- On Phase 1 the primary source is the Display Module.
- On Phases 2 to 4 the primary source is the Motor Controller module.
Each time, replacement of the module is the action. There is no secondary source.
Where the sensor fits
The pressure sensor is how the washer judges water level (code 11 speaks of it measuring water level). Code 2 concerns the reading of it. The sensor and its tube are not blamed here; a pressure tube that is blocked, kinked or detached is the separate code 39.
Your options
- Turn off at the socket and write the number down.
- Do not take panels off, since no owner check exists.
- Arrange service with the model number to hand.
Other pressure sensor entries
| Code | Manual wording |
|---|---|
| 6 | wrong signal arriving from the pressure sensor |
| 11 | pressure below zero while measuring the water level |
| 38 | level taken as empty during agitation |
Washer repair in Miami, New York, Houston, Los Angeles and San Diego
If a Fisher & Paykel washer in one of those metro areas shows code 2, call (844) 659-2290. The model number and the moment the code first appeared help us.
Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.