Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 6: Pressure Sensor Signal

Error code 6
Appliance Washer
Quick answer

Code 6 is an incorrect pressure sensor signal. The manual calls for replacing the module that received it.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 6 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

The Motor Controller (Display on Phase 1) received an incorrect signal from the pressure sensor on Phase 1 to 4 washers.

What does 6 mean in the manual? An incorrect signal came from the pressure sensor. Phases 2 to 4 have the Motor Controller module receive it; on Phase 1 it is the Display module.

At a glance

Code 6
What it means The Motor Controller (Display on Phase 1) received an incorrect signal from the pressure sensor on Phase 1 to 4 washers.
What you can check Turn the washer off at the wall and note the model number from its label. No owner check or reset exists for this code.
When to call a technician If 6 returns, a technician should look at it. The usual fix is replacing the module that receives the pressure signal, which means opening the machine.

The pressure sensor

Water level in the tub is measured by the sensor through a tube. The manual states only that the signal was incorrect.

Entry at a glance

Point Entry
Primary source Motor Controller module (Display module on Phase 1)
Action Replace that module
Machines Phases 1 to 4

A tube check is not part of code 6. Other numbers, set out below, cover tube problems.

Phase and module

The module named depends on which generation the washer belongs to. The fault list is arranged by Phase 1 to 6. In the model table, Phase 1 holds the GW500, GW600 and GW700 families and Phase 2 holds the GW701, GW601 and GW501. Check your own machine before using the replacement advice.

Codes easily confused with 6

  • Code 2 covers an error when trying to read the pressure sensor.
  • Code 11 covers negative pressure detected while measuring the level.
  • Code 39 covers a pressure tube that is blocked, kinked or fallen off.

Washer service in the metro areas we cover

From Miami, New York, Houston, Los Angeles or San Diego, phone (844) 659-2290 if 6 returns. Have the model number from the machine’s label in front of you.

Source: Fisher & Paykel Phase 6 Series 11 (GWL11) supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis