Error 38 is recorded when the water level reads empty mid-agitate; the pressure tube is the manual's first stop.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 38 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The Motor Controller recorded an empty water level during agitate, probably from a severed or detached pressure tube, or a faulty sensor.
How it comes about
Agitation does not begin in an empty tub, so water must have been seen earlier. Once the level reads empty during that agitation, 38 is recorded, filed by the manual as a Pressure Sensor Fault for Phases 1 to 6.
At a glance
| Code | 38 |
|---|---|
| What it means | The Motor Controller recorded an empty water level during agitate, probably from a severed or detached pressure tube, or a faulty sensor. |
| What you can check | There is no owner check or reset for code 38. Note when in the cycle it came up, because the entry rests on the level reading during agitation. |
| When to call a technician | The tube runs inside the washer, so a technician must open it to inspect it. Give the code, the model and the point in the cycle. |
| Point | Manual’s entry |
|---|---|
| Logged event | Level empty while agitating |
| Most probable cause | The sensor’s hose was cut or dropped off while agitating |
| Other cause | The sensor is faulty |
| First, mechanically | Tube undamaged and uncut |
| Then | With the tube showing nothing wrong, new controller module (Phase 1: Display Module) |
The pressure tube explained
How high the water stands is sensed via the tube. The manual names two connection points, on the tub and on the controller module, and gives the same instruction for tubes under several codes: attached, uncut, clear.
Whose job is it
Seeing the tube means opening the washer, since it runs inside. There is no owner check or reset for 38 in the manual. Tell the technician the code and when in the cycle it came up, because the entry rests on the level reading during agitate.
Related tube and sensor entries
- Code 39 covers a tube that is plugged, bent or detached.
- Code 11 is a negative pressure seen during the level measurement.
- Code 2 is a problem taking the sensor’s reading.
Verify before replacing
Two points open the booklet. Whatever code is on the display is the last fault recorded, and confirming it is always advised. Sources under each code are generally ranked from likeliest downward, but the order is now and then rearranged for easier servicing. Here the tube leads and the controller follows.
Smartdrive washer repair in the Miami, New York, Houston, Los Angeles and San Diego metro areas
Call (844) 659-2290 to arrange a visit, with the model and code to hand.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.