Fisher & Paykel Freezer Code 16: PC Fan Overcurrent
Fault 16: PC fan current is above expectation on Active Smart units.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 16 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
PC fan current is higher than expected, caused by shorted wiring or a faulty fan.
Seeing 16 on the display means the PC fan, the one serving the fresh food compartment, uses more current than it should. It is the high-current counterpart to 15. The manual’s explanation is either shorted wiring or a fan fault.
At a glance
| Code | 16 |
|---|---|
| What it means | PC fan current is higher than expected, caused by shorted wiring or a faulty fan. |
| What you can check | Write down which LEDs are lit, since the lit values add up to the code. Press a button to quiet the alarm, unplug for a few seconds to reset it, or wait 72 hours. |
| When to call a technician | There is no owner step, so book a technician to check the fan wiring and the fan. Say whether the fault followed a power cut or a door opened during start-up. |
15 versus 16
| Fault | PC fan current | Reason in the manual |
|---|---|---|
| 15 | Under expectation | Open circuit wiring or faulty fan |
| 16 | Over expectation | Shorted wiring or faulty fan |
In both cases the wiring runs to a mains-powered module, so any inspection is left to a technician.
What the manual says to do
The primary step is checking wiring and connections for the PC fan, both at the fan and at the power module. The secondary step is checking the fan, with replacement if it has failed. Nothing is listed for the owner.
Role of the fan
Such a fan keeps air moving in its compartment so that the cold made at the evaporator gets spread around. The manual goes no further, and it never says what a person would see at the door when the fan acts up.
Before the visit
- Write down the LEDs that are lit. The fault is shown in binary and the lit LEDs add up to the number.
- If the alarm sounds, press a button to quiet it for now.
- Unplug for a few seconds to reset the alarm, or wait: it clears on its own after 72 hours.
Other codes to compare
- Code 15: same fan, too little current
- Code 18: FC fan, too much current
- Code 12: heater and fans, combined current too high
Freezer repair in the metro areas
Fisher & Paykel freezer repair is handled in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Phone (844) 659-2290 with code 16 and the model number from the unit, and report whether the fault followed a power cut or a door opened during start-up. See refrigerator repair.
Source: Fisher & Paykel Active Smart Refrigerators USA service manual 517775, section 1.0
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.