Fisher & Paykel Washer Error 10 Code: Thermistor Fault
Error 10 on Fisher & Paykel GW and Intuitive washers relates to the thermistor. The service manual's remedy is a replacement thermistor.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 10 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Error 10 is a thermistor fault, open circuit or ambient below minus 10 C, listed for Intuitive and GW models on Phases 1 to 6.
What the manual says
The service manual from Fisher & Paykel lists fault 10 as a thermistor error. The thermistor measures water temperature. Either the sensor circuit is open, or the ambient temperature has fallen below minus 10 C. This fault is confined to the Intuitive Washer and GW models.
At a glance
| Code | 10 |
|---|---|
| What it means | Error 10 is a thermistor fault: the water temperature sensor circuit is open, or the ambient temperature is below minus 10 C. |
| What you can check | If the washer is not running normally, switch it off at the wall and note what it did when it stopped. |
| When to call a technician | A technician is needed, since the fault points to a sensor that has to be tested and replaced inside the machine. Pass on the washer's behavior and the model name. |
The meaning of “open circuit”
An open circuit means a gap somewhere along the electrical route, and the control receives no reading whatever. Fault 41 shows the opposite pattern, with a reading above 110 C and a suspected short in the wiring of the sensor.
Remedy in the manual
- The thermistor is named as the primary source.
- The action is to replace the thermistor.
For the Series 11 Ecosmart the manual puts the thermistor in the inlet chamber and lists it as its own spare, number 479164P, rated at 10,000 ohm at 25 C. The entry offers an owner nothing to do.
Checking your model
The fault is listed across Phases 1 to 6 but restricted to GW and Intuitive models. GW500 to GW711 and IW509 to IW811 are among the numbers in the manual’s table. The label on your washer shows which you have.
Meanwhile
- If the washer is not running normally, power it down at the wall.
- The code stands for the last fault recorded, so pass on to the technician what the machine did when it stopped.
Companion codes
- 237: a Phase 6 sensor error, described as the continuity problem shared with 10 and 41
- 41: a thermistor measuring above 110 C
Washer service in the metro areas we cover
Service for Fisher & Paykel washers runs in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Phone (844) 659-2290 and give the model name and fault number.
Source: Fisher & Paykel Phase 6 Series 11 (GWL11) service manual 517766, Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.