Fisher & Paykel Washer Code 237: Temperature Sensor Error
237 means the temperature sensor circuit has a continuity problem. The thermistor is replaced first according to the manual.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 237 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Phase 6: temperature sensor error, a continuity problem the manual says is the same as codes 10 and 41.
Code 237 is the Phase 6 “Temperature Sensor Error”. The electronics have spotted a continuity fault, and the manual treats it as equivalent to 10 or 41.
At a glance
| Code | 237 |
|---|---|
| What it means | Phase 6 washers show a temperature sensor continuity fault, treated as the same as codes 10 and 41. |
| What you can check | Power the washer down and unplug it before anyone touches the wiring around the sensor. |
| When to call a technician | Schedule a visit, since a technician must replace the thermistor or inspect the connections and, if they are fine and the fault stays, fit a new controller. Quote the model number. |
Ranked sources
| Order | Cause | Remedy |
|---|---|---|
| 1 | Sensor failure, in the wiring harness or where the thermistor plugs in | New thermistor (temperature sensor) |
| 2 | Temperature not read by the Motor controller | Inspect connections; new Motor controller if they are fine and the fault stays |
The controller is at the bottom, and connections get checked ahead of replacing it.
Plain-language terms
- A thermistor is a small sensor whose resistance varies with temperature, giving the washer its water temperature.
- Continuity is an intact path for current; with 237 the path is faulty.
For the owner
Nothing in the list is aimed at owners. Power the washer down and unplug it before wiring around the sensor is touched.
Other numbers for the same fault
- 10: sensor circuit open, or a surrounding temperature below -10 C.
- 41: reading above 110 C from the thermistor, likely a short in its wiring.
Washer repair by phone
Fisher & Paykel washer repair is available around Miami, New York, Houston, Los Angeles and San Diego. Phone (844) 659-2290 with the model number and code 237.
Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.