Fisher & Paykel Washer Code 41: Temperature Sensor Fault
Code 41 flags a thermistor reading over 110 C, probably a short circuit in its line. It applies to GW and Intuitive machines.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 41 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The wash-water thermistor is measuring above 110 C, probably because of a short circuit in the sensor line.
The fault in brief
A figure over 110 C from the temperature sensor makes the washer show 41. For the manual, the probable reason is a short circuit along the sensor line. Phases 1 to 6 list the code; it is relevant to Intuitive Washer and GW models.
At a glance
| Code | 41 |
|---|---|
| What it means | The wash-water thermistor is measuring above 110 C, probably because of a short circuit in the sensor line. |
| What you can check | The washer must be unplugged before anyone tests the sensor with a meter. |
| When to call a technician | A technician follows different steps depending on the washer's phase. Tell them the phase or model if you know it. |
Phase-by-phase actions
| Phase | Manual starts with | Sequence |
|---|---|---|
| 1 | Motor Controller | 12 way harness connections; console area checked for moisture; new Motor Controller; then a new Display Module, with the first Motor Controller refitted if the display clears the fault |
| 2 to 4 | Motor Controller | Swap the module, no other step |
| 5 and 6 | Thermistor | Link from thermistor to Motor Controller; a good thermistor reads 12.5k ohms at 20 degrees C (68 F), a faulty one is replaced; then the Motor Controller |
Sensor background
- Its job is measuring the wash water temperature.
- An NTC device, in the manual’s words, with 10,000 ohms at 25 C.
- In the ecosmart it is fitted in the inlet chamber and ordered as its own spare.
- Resistance is read with a meter, and the washer has to be unplugged.
Not to be mixed up with code 10
Code 10 is the opposite fault, an open circuit or a surrounding temperature under minus 10 C. Code 237, the Phase 6 continuity problem, is likened by the manual to both 10 and 41.
Washer repair in the five metro areas
Service for Fisher & Paykel washers in Miami, New York, Houston, Los Angeles and San Diego is reached on (844) 659-2290. State the phase or model if you know it, as the steps vary by phase.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.