Fisher & Paykel Washer Fault 14: Pump Connection Fault
Fault 14 on Phase 1 Fisher & Paykel washers is the pump failing to run when the Display module wanted it on.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 14 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Phase 1 Pump Connection Fault: the pump was not on at a time when the Display module expected it on.
On Phase 1 machines, 14 is the “Pump Connection Fault”. The Display module wanted the pump running and found it not on. Fault 13 describes a pump running while it ought to be idle.
At a glance
| Code | 14 |
|---|---|
| What it means | Phase 1 Pump Connection Fault: the pump was not on at a time when the Display module expected it on. |
| What you can check | Allow time for a tripped thermal cut-out to cool; it resets by itself. Turn the power off at the wall and notice whether you heard the pump start. |
| When to call a technician | A technician is needed, since testing the pump and its wiring takes a meter and access inside the machine. Tell them whether the pump started. |
Source and sequence
| Item | Manual entry |
|---|---|
| Primary source | Pump |
| Step 1 | Check the pump’s thermal cut-out; once it has operated, cooling time is needed before a new start. A blocked or seized pump is ruled out at the same stage. |
| Step 2 | Winding resistance of the pump shows whether the circuit is open. |
| Step 3 | Harness and connectors serving the pump are checked for an open circuit as well. |
| Step 4 | Fit a new Display module. |
Reading the wording
An interruption of the electrical path that stops current is what “open circuit” refers to. The word “connection” in the title points to the pump or its plug as a possible location, though the manual stops short of saying so.
Advice for owners
- A tripped thermal cut-out resets as it cools, as noted by the manual in its pump section. Patience is step one, which is not a repair.
- Meter readings and access to the machine’s inside make pump and wiring tests a matter for service staff.
Which washers
Phase 1 models are GW500 with GW600 and GW700, then GW050, GW060 and GW070, with the GW650 as well. Later phases list their own pump codes.
Also see
- 13: a pump seen running when it should be idle.
- 37: a blocked pump, with the water level unchanged while draining.
Washer repair around Miami, New York, Houston, Los Angeles and San Diego
Ring (844) 659-2290 for Fisher & Paykel washer service in these metro areas. Tell us whether you heard the pump start.
Source: Fisher & Paykel Phase 6 Series 11 (GWL11) service manual 517766, Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.