Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 236: Wrong EEPROM Version

Error code 236
Appliance Washer
Quick answer

236 shows straight away and the washer will not start. The manual's cause is a wrong Motor Controller; the action is to replace it.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 236 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

Phase 6: incompatible EEPROM version; the wrong Motor Controller is fitted, the machine fails to start and the fault is displayed immediately.

“Failure to start and fault immediately displayed” is how the service manual describes 236, which it lists on Phase 6 washers as “Incompatible EEPROM Version”. Rather than appearing late in a cycle, it comes up as soon as the machine is asked to run.

At a glance

Code 236
What it means Phase 6: incompatible EEPROM version; the wrong Motor Controller is fitted, the machine fails to start and the fault is displayed immediately.
What you can check Note the model number and whether the washer ran before the code appeared.
When to call a technician Book a repair, as the machine fails to start and the display shows the fault at once because the wrong motor controller is fitted. A matching one must be ordered by model.

Cause and cure

  1. Primary fault: the motor controller fitted is the wrong one.
  2. Action: replace the motor controller.

The entry says nothing more, so no owner check or reset is on offer.

What follows from it

  • The remedy is a matching Motor Controller, which makes the washer’s model number important for ordering.

Close relatives

  • 230: the manual’s other wrong-version entry; the EEPROM value is out of range and a wrong version is detected.
  • 161: hardware configuration against EEPROM table mismatch, a different entry whose action is likewise a new Motor Controller module.

What the entry leaves out

There is no number of wrong controller types, no method of reading the version from the module, and no owner test. Nor does it say whether the washer is shut out of all cycle options or only of starting. The words used are failure to start, and the source goes no further.

Washer repair across the metro areas

Call (844) 659-2290 for Fisher & Paykel washer repair in the Miami, New York, Houston, Los Angeles and San Diego areas. Quote the model number and mention if the washer ran before the code appeared.

Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis