Skip to content
Same-day and next-day appointments in most areas.
Specialized Fisher & Paykel repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Fisher & Paykel Washer Code 161: Supply Mismatch

Error code 161
Appliance Washer
Quick answer

Fault 161 means the machine's hardware setup does not match its stored table at power-up. Replacing the Motor Controller is listed.

Model compatibility: Fisher & Paykel reuses codes across series and model years, so 161 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.

Plain language

What this code means

At power-up the Motor Controller found its hardware configuration and EEPROM table do not match.

Power-up is when fault 161 is detected. The manual lists it as “Hardware / EEPROM Supply Mismatch”. A comparison takes place inside the Motor Controller between its physical build (“110v or 230v” is the manual’s example) and what its memory table says; a difference triggers 161.

At a glance

Code 161
What it means At power-up the Motor Controller found its hardware configuration and EEPROM table do not match.
What you can check Cut the power at the wall, keep the cabinet shut, and write down the code and model number.
When to call a technician Arrange a visit, because this is a configuration problem inside the electronics and the controller module is replaced. Say if the washer was recently moved or started from cold.

Plain-language terms

  • Motor Controller: the electronics module driving the motor.
  • EEPROM: a small chip in which that module keeps its settings.

Affected machines

Phases 2, 3, 4, 5 and 6 are covered. Phase 1 is not.

The entry at a glance

Field Content
Primary source The Motor Controller module
Action A new Motor Controller module goes in
Checks by the owner None given

This is a configuration problem inside the electronics, which is why it appears at power-up. Hoses, filters and the load make no difference, and the manual gives neither another cause nor an owner-level step.

Advice

Cut the power at the wall and keep the cabinet shut. Jot down the code and the model number, and arrange service.

Related codes

  • 230: EEPROM out of range and a wrong controller version found; Phase 6 alone.
  • 236: EEPROM version incompatible, meaning the wrong controller is fitted.
  • 3: a memory problem picked up by the controller.

Washer service in the metro areas

For repair visits in the Miami, New York, Houston, Los Angeles and San Diego metro areas, phone (844) 659-2290. Give the model number and the code, and mention if the washer was recently moved or started from cold.

Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

References

Sources & references

Code still active?

Have this Fisher & Paykel alert verified on site

Repeating fault codes usually need platform-specific testing. We confirm the cause and price the fix before work begins.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book diagnosis