242 is a Phase 6 out-of-balance warning whose checks are written under code 43.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 242 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Phase 6: out-of-balance hit over the maximum for 5 seconds, from excess tub movement or a micro switch stuck on or with a loose harness.
What the entry says
Out of balance is what OOB abbreviates in 242, which the manual describes as a warning to the user and an additional Phase 6 code. The reading exceeded its maximum for a full 5 seconds.
At a glance
| Code | 242 |
|---|---|
| What it means | The washer detected out-of-balance for 5 seconds, from excess tub movement or a stuck switch or loose harness. |
| What you can check | Switch the washer off first, then see whether it sits level. Anything involving the switch or its harness is a technician's job, so leave those alone. |
| When to call a technician | Call a technician for any switch or harness work. Mention whether the washer was visibly moving about while spinning, since that helps narrow down the cause. |
Two possible causes
- The machine registered excessive movement of the tub.
- The micro switch is stuck in the on state, or the harness that serves it has come off.
The manual’s direction is simply to look up code 43.
Checks held in code 43
That entry is the same on all phases. It asks that the out of balance switch moves freely, that no harness gets in its way, and that the switch behaves correctly when activated, with a replacement if in doubt. A corroded micro switch is replaced along with its harness, and a condensation kit is fitted in the console area if the top deck has none built in. Level and bias spring complete the list.
What you can reach yourself
- Switch the machine off before anything else.
- See whether it sits level; the manual counts level among its checks.
- Leave switch and harness work to a technician.
Entries in the same area
Fisher & Paykel washer repair across our metros
Washer repair in the Miami, New York, Houston, Los Angeles and San Diego metro areas starts at (844) 659-2290. Say whether the washer was visibly moving about while spinning.
Source: Fisher & Paykel supplementary service manual 517766, section 19 Detailed Fault Codes
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.