Fisher & Paykel Washer Code 44: Water in Tub at Spin
Code 44 means water was detected in the tub while spinning, with a slow pump-out from a partial blockage as the manual's explanation.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 44 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Water was sensed in the tub during spin, possibly from slow pump-out caused by a partial blockage.
What the code says
Code 44 carries the title Water in Tub during Spin and is documented for Phases 2 to 6. A spin ought to run on an emptied tub, yet the Motor Controller still sensed a water level. The reason offered by the manual is slow pump-out due to a part blockage somewhere in the pump hose or the pump itself.
At a glance
| Code | 44 |
|---|---|
| What it means | Water was sensed in the tub during spin, possibly from slow pump-out caused by a partial blockage. |
| What you can check | Check that the drain hose is not squashed or kinked and that any extension is only one piece of 39 in (1 m) with the same diameter. |
| When to call a technician | When the hose is fine, a technician is needed, since the pump, top deck and basket must be removed and the tub bailed out. Describe the hose set-up when you call. |
Items from the pump-system section
- The drain hose should be neither squashed nor kinked.
- Its length should not be excessive; one extension of 39 in (1 m), with the same diameter, is the limit.
- If the tub is empty, take the pump from its housing and inspect pump and hose for a blockage.
- If the tub holds water, the pump is reached from above: lift out the top deck and basket, scoop out the water, remove the cap and hood of the pump, and clear the obstruction.
- Watch for water siphoning back in as the pump stops, which is when the spin speed gets to 700 rpm.
With everything above in good order, the Motor Controller module is the secondary source and the manual replaces it.
Light versus heavy steps
| Step | Nature |
|---|---|
| Hose not kinked, hose length | Visual or measuring check |
| Removing pump, top deck, basket; bailing water | Service task |
The manual puts the speed at which the pump turns off at 700 rpm.
Related codes
Code 37 applies the same hose-length rule while draining, code 36 deals with siphoning in agitate, and code 12 is the flood protection error.
Slow-draining washer service by metro area
People in the Miami, New York, Houston, Los Angeles and San Diego areas can phone (844) 659-2290 about a washer that will not clear its water. Report what the drain hose looked like.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.