Error 36 is a water leak fault after over 4 top-ups in agitate, usually siphoning and otherwise a leak.
Model compatibility: Fisher & Paykel reuses codes across series and model years, so 36 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
The Motor Controller topped up the water more than 4 times in agitate, indicating siphoning or a leak.
What triggers the fault
Air leaves a full load while the drum agitates, which the manual gives as the reason for one or two top-ups being normal. A fifth top-up or beyond, described as excessive, makes 36 appear. The code is called Water Leak Fault, and it applies across Smartdrive Phases 1 to 6.
At a glance
| Code | 36 |
|---|---|
| What it means | The Motor Controller topped up the water more than 4 times in agitate, indicating siphoning or a leak. |
| What you can check | Measure the outlet end of the drain hose, which must sit between 33.4 in (850 mm) and 47 in (1200 mm) high, with no more than 3/4 in (20 mm) of hose past the guide. |
| When to call a technician | Call a technician if the hose is correct, as seals and tube joints sit inside the cabinet. Mention any water collected around the washer, since a leak is one explanation. |
Causes named
- The likelier one is siphoning by the machine.
- The other is that a leak has developed.
Checks, ordered as in the manual
Pump system, primary
- The outlet end of the drain hose has to sit between 33.4 in (850 mm) and 47 in (1200 mm) high, so measure it.
- A hose guide should be present, with no more than 3/4 in (20 mm) of hose protruding past it.
Mechanical, secondary
- Look over the pressure tube joints, one on the tub and the other on the controller module.
- Check that neither the drive shaft seal nor the pump housing seal has begun to leak.
Motor Controller, tertiary
With every earlier item in order, the manual finishes by calling for a new controller module, the Display Module on Phase 1.
Division of work
From outside, with only a tape measure, you can examine hose height and guide. Inside the cabinet sit the seals and tube joints, which a technician handles. If water has collected around the washer, say so on the phone, since a leak is one of the manual’s two explanations.
Codes in the same neighborhood
- Code 44 is about hose length and kinks and water running back in too, at the spin stage.
- Code 37 reports a pump that is blocked and comes with similar hose guidance.
- Code 39 has to do with the pressure tube.
Washer repair in the Miami, New York, Houston, Los Angeles and San Diego metro areas
For siphon or leak trouble on a Fisher & Paykel washer, call (844) 659-2290 and state the hose height you measured.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Sources & references
Tell us what’s wrong — we’ll take it from there
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.